Tubular heating element are custom designed in a various shapes to as client’s requirements for direct immersion in liquids such as water, oils, solvents and process solutions, molten materials as well as air and gases. Tubular heaters are produced using Incoloy, stainless steel or Copper sheath materials and also there is huge variety of selection of termination styles available. Insulation of Magnesium offers greater heat transfer. Tubular heaters can be used in any application. Straight tubular can be inserted in machined groves for conductive heat transfer and formed Tubular provides consistent heat in any type of special application. 

Adopting U shape tubular heating element ,according to design standard of different mediums,and power requirement to installed in the flange shell.Insert the electric element into the material which need to be heated ,immense heat will be produced when Heating elements works ,then conducted to heated medium for temperature increasing and meet the technology requirement.when the medium temperature reach the set value,control system can output power though PID calculation, according to the temperature sensor signal. Achieve temperature controlling for resistive load of heating element ,make medium temperature evenly and meet requirement.when the heating element exceed temperature or lower than position ,Interlock protection device can cut off heating power to avoid element broken,and extend using life. 

·Water Deionized, Demineralized, Clean, Potable, Process

·Industrial Water Rinse Tanks

·Vapor Degreasers

·Hydraulic Oil, Crude, Asphalt

·Lubricating Oils at API Specified Watt Densities

·Air and Gas Flow

·Caustic Solutions

·Chemical Baths

·Process Air Equipment

·Boiler Equipment

·Tube diameter: 6.5mm-14mm

·Tube Material: SS304, SS316, SS321 and INCOLOY800 etc

·Insulation Material: MgO

·Conductor Material: Nichrome Resistance Wire

·Wattage Density: High/Middle/Low (5-25w/cm2)

·Lead Connection Option: Threaded Stud Terminal or Lead Wire

·Lead Wire Type: 300mm Standard (Teflon/Silicone High Temperature Fiberglass are available for 15KW Electric Heater Element)

We can send the sample to you for free. you can test our quality